How to check if you have a water pipe leak
With a water pipe leak, it’s commonly said that prevention is the key. Positive preventive maintenance saves you thousands of dollars in hassles and water damage.
That’s why you want to follow the simple step by step check for a water pipe leak. This will prevent the hassles before they hit you where it hurts most – in your pocket!
Step by Step Instructions
Below we run through:
- Check your taps
- Check your toilets
- Turn the taps off
- Check your water meter
- Wait 15 minutes
- Compare water meter readings
- Turn the taps back on
- When to call a plumber
- When your good to go
At Whywait Plumbing, we have always preached that preventative maintenance policies and procedures will prevent many of the significant cost blowouts in plumbing maintenance.
As always, prevention on checking for a water leak is the best solution. An underground concealed water pipe leak is often impossible to see or hear. More so if your home is on sandy soil or has lots of garden vegetation.
The simplest way to check if you have a concealed water pipe leak is to follow the how-to steps below:
Step 1 – Check your taps
Check all taps both inside the house and outside the house are not dripping.
Step 2 – Check your toilets
Check the toilet cisterns are not overflowing or running into the toilet bowl by tipping a few drops of food dye into the cistern and if there is no colouring of the water in the toilet bowl you know there is no leak.
Step 3 – Turn the taps off
Turn off all the taps that you normally leave turned on, such as the washing machine, dishwasher and the toilet cisterns.
Step 4 – Check your water meter
At the council water meter check the meter is not turning and write down the figures on the meter dial.
Step 5 – Wait 15 minutes
After 15 minutes recheck the water meter and write down the figures on the meter dial again.
Step 6 – Compare water meter readings
Compare the figures you have written down, and if the numbers have not changed at all, then you have no water pipe leak. If the numbers have changed very slightly repeat the test but do it for at least 1 hour.
Step 7 – Turn the taps back on
If you are satisfied there are no leaks remember to turn back on the taps you turned off at the washing machine, dishwasher and toilet cisterns.
Step 8 – When to call a plumber
If the meter dial reading on the water meter has changed after 1 hour then in all likelihood you have an underground concealed water pipe leak, and you need to give Whywait a call to organise leak detection.
Step 9 – When your good to go
If the meter dial reading has not changed, that means your underground water reticulation piping is in good condition.
Prevention is the key
No matter what your results in the above step by step preventative maintenance suggestions, we recommend you repeat it monthly. We also recommend you record your water meter readings every month as any change in water use patterns will quickly indicate a possible leak.
As a rule of thumb, YOU ARE RESPONSIBLE for any water leak after the council water meter that is on your property. Therefore we recommend that you at least check your water meter reading every month and seriously consider the installation of an AquaTrip water pipe leak detection and control system.
